Injection Moulding PMSM Motors

Home Servo Motors Injection Moulding PMSM Motors

Injection moulding PMSM motors

Your benefits of using “MARK” PERMANENT MAGNET BRUSHLESS AC SERVO MOTORS (Injection moulding servo motors):

Product benefits Customer benefits
Substantial Reduction in energy consumption and therefore reduced energy costs with Injection moulding servo motors Quick Recovery of any higher initial costs for Injection moulding servo motors and servo drive usually within 1 year
Better control characteristics due to Injection moulding servo motors Easy replacement of electronic-hydraulic variable pump
Integrated closed-loop control in converter; better hydraulic control Ability to connect to machine controller without difficulty (Plug & Play) > Retrofits can be made without adapting the control system We have partners to provide retrofits
Higher efficiency than a controlled asynchronous motor with variable pump Minimal operating costs
Close partnership with system manufacturer for optimal system design Optimal design with respect to costs, noise and energy efficiency
Less heating, thus allowing a lesser cooling requirement More compact machine design and additional cost reduction due to less cooling demand
Lower noise generation of Injection moulding servo motors Less effort required for noise insulation

Features Of “MARK” Permanent Magnet Brushless Ac Servo Motors (injection Moulding Servo Motors)

  • Compact design & high power density
  • Rare Earth high energy magnets
  • Constant Torque (rated) on entire speed range
  • Low Noise & vibration levels
  • Totally enclosed design
  • Low rotor inertia

Technical Data for Injection moulding servo motors:

Frame Size – IEC Foot Cum Flange Rated RPM range Rated Torque NM Rated KW Output @ max. rated RPM
100 L 1500 - 3000 40 NM 12.5
112 L 2000 - 2400 60 NM 15.0
132 S / 132 1500 - 2400 90 NM 22.0
132 L / 160 M 2000 - 2400 120 NM 30.0
160 L 1500 - 2000 180 NM 37.0

TECHNICAL SPECIFICATION OF “MARK” PERMANENT MAGNET BRUSHLESS AC SERVO MOTORS (Injection moulding servo motors):

  • Enclosure – IP 54
  • Temperature Protection for windings, thermister / thermal switch
  • Insulation Class ‘F’
  • Cooling – forced air cooling by axial blower motor.
  • Frame : Cast Iron & Mounting as per standard drawing foot cum flange
  • Bearings – Deep groove ball bearings.
  • Speed Feedback at N.D.E.
    • Incremental / sin cos encoder
    • Resolver
  • Number of Poles 8 / 6
  • Rated Voltage 380 V (Max.), 3 Phase.